How can I open an old Mason jar with a rubber gasket without breaking the glass? - how to can with rubber canning jars
If you support the guy with a metal cap by a ring, then make a hole in the lid with a can opener. If the old style Ting board with a stick, then take the tab tab with pliers and pull them aside to get it from.
Sometimes when you are frozen, not escape a poor job and syrup, in cans or stuck like glue, then wash with warm water, soak for OT this sticky sweet substance.
Friday, January 29, 2010
How To Can With Rubber Canning Jars How Can I Open An Old Mason Jar With A Rubber Gasket Without Breaking The Glass?
4 comments:
In the case of oxide that the lid will come out, should be careful. If the content is filtered, run a site, the content is not good. Try with hot water, and then press the side of a case or a butter knife (the handle). This break is usually enough to break the seal. If you do not help, more than a platform for improved grip, too, with a damp cloth so that you get a good grip.
The aim is to relieve pressure from within, without pressure on the bottle. The hot water will do, when pushed tack or small nail through the tip. N sink
Normally, the Ribber at the bottom (sealed) were killed and evaluated after the introduction. Take your time, if the water is not effective. Add to wait for hot water and ... Work.
run it under hot water for a while and then open a towel and
I think you have captured one of the old bottle with a glass lid with a metal clip. First, all soaked in hot water. If it were a tab that protrudes through the rubber seal a few (this way), pull it, try to get the ring or in parts. You should be able to receive care. When the rubber has hardened, or it is sticky, it can not still be in the bottle should probably not be eaten.
Post a Comment